Thread: Domed pins
View Single Post
  #3  
Old 04-24-2011, 09:16 AM
rebglass rebglass is offline
Steel Addict
 
Join Date: Jul 2002
Location: Yellville, Arkansas
Posts: 123
Thanks for this. This may address part of the problem - my head spinner doesn't seem to cut very well. I don't like the appearance of the pins that are domed after they're installed. Don't like the little "mote" that the spinner digs around the pin. I'm trying to get the look of the domed pin sitting nicely on top of the handle material - with the handle material being properly prepared before installing the pin. If that makes any sense. Thanks for the link.
Reply With Quote