View Single Post
  #12  
Old 04-21-2011, 12:16 PM
Don Robinson's Avatar
Don Robinson Don Robinson is offline
Hall of Famer
 
Join Date: Jan 2003
Location: Brownsville, Texas
Posts: 4,873
Preparing to mill the blade flats.

The blades are mounted on the plate using a 1/4" cap screw. The other end will be held in place with a milling clamp.

Note that I've lined up the cutting edge of the blade on the left parallel to the plate.
Attached Images
File Type: jpg DSC02875.jpg (151.1 KB, 338 views)
File Type: jpg DSC02876.jpg (65.7 KB, 300 views)